Ricoh FT5034C Service Manual page 231

8. Hook the sorter adapter [F] on the screws,
and tighten the screws to fix the adapter.
9. Install the mount stay on the copier with
two screws (M4 x 25) [G].
10. Install the front and rear hinge brackets [H,
I] on the copier with four screws (M4 x 6 -
Tapping).
11. Attach the sorter to the hinge brackets by
positioning the lower support shaft in the
fork shaped groove of the hinge bracket.
Tilt the sorter at an angle of 5 degrees
while setting it in the bracket.
NOTE: Make sure that the hook of the
tension spring is properly
positioned on the bracket.
12. Install two tapping screws (M4 x 10 -
Tapping) [J] on the front and rear lower
bracket of the sorter.
13. Feed the connectors (2P, 3P) of the sorter
into the square holes in the rear hinge
bracket from the rear side. Connect two
connectors from the sorter adapter with
these connectors.
- 4 -