Ricoh FT5034C Service Manual page 248

2.3 OPERATION CHECK
1. Turn on the main switch and confirm that the insert original indicator (
2. Wait for the ready condition.
NOTE: It takes about 2 minutes.
3. Square a stack of originals and insert the originals until the insert original
indicator goes out.
4. Press the Start key, then the ADF should start operating.
5. Check if the original jam indicator lights when a paper jam is incurred by grabbing
the original which is supposed to be fed in.
6. After removing the jammed paper from the ADF, the original jam indicator should
go off when the ADF returns to its original position.
7. Square the stack of originals, and reset the originals.
2.4 NON-RECOMMENDED TYPES OF ORIGINAL
CAUTION: The following types of originals are not recommended for use
with the ADF. Please place them directly on the exposure glass of
the copier.
1. Originals thicker than 105 g/m
2. Paper with any kind of coating (such as carbon) on the back, or originals that are
taped together.
3. Folded, curled, creased or damaged originals.
4. Bound, stapled, or clipped originals.
5. Mailing labels, perforated originals, or pasted originals,
6. OHP transparencies.
7. Thermal fax paper.
2
or thinner than 52 g/m
- 5 -
2
.
) lights.