Components List; Installation Overview; Placement Clearance Requirements - kozy heat NICOLLET NCL-195 Installation And Operation Manual

MODEL #NCL-195 COMPONENTS LIST
(#NCL-600-IPI) - IPI Board Assembly with 18" Flexible Gas Line attached
(#700-208) - IPI Remote Control
(#700-203) - Manual Gas Shut-off Valve
(#NCL-135) - Burner Assembly
(#NCL-LK) - Light Kit
(#TWO-005) - Glass Valance
(#TWO-15T) - Glass with gasket
(#600-002) - Double Receptacle Assembly with (3) Wire Nuts
(#OCK-A60L-IPI) - LP Conversion Kit
(#900-086) - 5" Restrictor Plate
(#TWO-HHS) - Horizontal Heat Shield
ADDITIONAL COMPONENTS REQUIRED
Vent System: Approved venting listed on page 14 of this installation manual.
Fireglass: Various colors available. See Dealer for details.
Contemporary Frame: Various finishes available. See Dealer for details.

INSTALLATION OVERVIEW

1. Frame an opening for fireplace, allowing for vent installation and type of installation.
2. If masonry (optional) will be used, prepare foundation for masonry load. A lintel is required to support added weight above fireplace.
3. Insert fireplace into framing.
4. Install hearth (if applicable).
5. Complete gas line installation.
6. Complete electrical hook-up. Install any standard or optional electrical components at this time.
7. Complete venting installation.
8. Secure fireplace to flooring through holes located in outer box bottom and to framing with nailing flanges. Verify all clearances at this
point.
9. Install mantel or cabinetry, allowing room for (required) decorative full doors / faces.
10. Install fireglass.
11. Install (required) contemporary frame.
12. Verify proper operation of fireplace and all components.

PLACEMENT CLEARANCE REQUIREMENTS

This fireplace must be installed on a level surface capable of supporting fireplace and venting.
Fireplace must be placed directly on wood or non-combustible surface (not linoleum or carpet) extending entire depth and width of
fireplace.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
PAGE 7
NOTE: The qualified installer should follow procedure
best suited for the installation.