Technical Specifications - Outback omega 150 Assembly And Operating Instructions Manual

9.5. Grease Cup
After every use, empty and clean the grease cup
of any fat or food particles, using a plastic or
wooden scraper if necessary.
Failure to keep it clean, and excessive build up
can result in a fat fire. This can be hazardous and
severely damage the barbecue. This is not a fault
in the barbecue and is therefore not covered
by the terms of the warranty. If required, the cup
can be washed in hot soapy water.
9.6. Barbecue Body
Regularly remove excess grease or fat from the
barbecue body using a cloth wrung out in hot
soapy water and dry thoroughly. Excess fat and
food debris can be removed from inside the body
using a soft plastic or wooden scraper. It is not
necessary to remove all the grease from the body.
If you need to clean fully, use hot soapy water and
a cloth, or nylon-bristled brush only. Do not use
abrasives. Remove cooking surfaces and burners
before full cleaning. Do not immerse the gas
controls or manifold in water. Check burner
operation after carefully refitting into body.
9.7. Barbecue Hood or Lid & Trolley
Use a non-abrasive cloth or pad and clean with
hot, soapy water. Do not use scouring pads or
powders as they can permanently damage the
finish.
9.8. Fixings
All screws and bolts, etc. should be checked and
tightened on a regular basis.
9.9. Storage
Ensure the barbecue is properly cooled before
covering or storing. Store your barbecue in a cool
dry place.
Cover the burners with aluminium foil in order to
prevent insects or other debris from collecting in
burner holes.
If the barbecue is to be stored indoors, the gas
bottle must be disconnected and left outside. The
gas bottle should always be stored outside, in a
dry, well-ventilated area, away from any sources of
heat or ignition. Do not let children tamper with the
bottle.
When using the barbecue after extended periods
of storage follow the cleaning procedures.

10. Technical Specifications

CE
Approval Input
Outback®
0359
Omega 150
6.2kW
359BL239
MM095
Outback®
0359
Omega 250
6.2kW
359BL239
MM150
Side 0359
2.3kW
Burner 359BL239
Gas Consumption:
Omega 150: 446g/hr
Omega 250: 446g/hr
Side Burner: 165g/hr
Countries of Use:
I BE, CH, CY, CZ, ES, FR, GB, GR, IE, IT, LT, LU, LV, PT,
3+ (28-30/37)
SK, SI
I BE, CY, CZ, DK, EE, FI, FR, HU, IT, LT, NL, NO, SE, SI,
3B/P(30)
SK, RO, HR, TR, BG, IS, LU, MT
Specifications subject to change without prior notice.
19
Heat Injector
Burners Gas /Pressure
Size
0.89mm 28-30 mbar Butane
1
or 37 mbar Propane
0.89mm 30 mbar LPG mixture
0.89mm 28-30 mbar Butane
1
or 37 mbar Propane
0.89mm 30 mbar LPG mixture
0.74mm 28-30 mbar Butane
1
or 37 mbar Propane
0.74mm 30 mbar LPG mixture