Sony NXCAM HXR-NX100 Operating Manual page 20

Step 2: Charging the battery pack (Continued)
2
Connect the DC plug to the DC IN
jack of the camcorder.
3
Connect the power cord (mains
lead) to the AC Adaptor and the
wall outlet (wall socket).
4
Turn the ON/STANDBY switch to
STANDBY (1).
The CHG lamp lights up and charging
starts.
20
When charging ends
The CHG lamp turns off when the battery is
fully charged.
b Note
Even if the CHG lamp is not lit, the battery
charger is not disconnected from the AC power
source (mains) as long as it is connected to the
wall outlet (wall socket).
Disconnect the AC Adaptor from the DC
IN jack.
z Tip
• You can check the remaining battery life with
the status check function (p. 64).
To remove the battery pack
Turn the ON/STANDBY switch to
STANDBY (1). Press and hold the BATT
RELEASE button, and slide the battery up
and out.
BATT RELEASE button
To store the battery pack
If the battery pack is not in use for a while,
run down the battery and store it (p. 109).
Charging time
Approximate time (minutes) required when
you charge a fully discharged battery pack.
Battery pack
NP-F770
Full charge time
370 minutes