Harris ENC6800+ Installation And Operation Manual page 37

Table 3-3. Card-Edge Parameter Options— ENC/ENS6800+ Modules(Continued)
Bank,
Rotary Parameter Name
Switch
0, 6 Chroma Phase
0, 7 Video Output Standard
Set
0, 8 Active Video Setup
0, 9 Setup Starting Line
0, A For Future Use
0, B Fine Phase (ENS6800+
only)
0, C SCH Offset
0, D Reference Input Select
ENC/ENS6800+ Installation and Operation Manual
Function
Adjust the chroma phase with respect to
burst
Sets the video standard for the
Composite output
Controls the addition of the SETUP (7.5
IRE) pedestal signal to the active video
lines in 525 line standard for the analog
video output
Selects the start of the active video line
where the SETUP (7.5 IRE) pedestal is
being applied in 525 line standard for
the analog video output
Adjusts the output timing in fine
increments
Controls the SCH offset for the
composite video output to properly
construct the color framing sequence
Selects the reference input source
This parameter works in conjunction
with the J1 Local/Frame jumper setting.
See
"Setting Jumper J1 for Genlock
Source" on page 13 for more
information.
Chapter 3: Operation
Parameter Option
±180°
(0°)
• NTSC
(525 LED is
green)
(525: NTSC)
• PAL-M
(525 LED is
orange)
• PAL-B
(625: PAL-B)
• Off
• On
10-22 Ln
(22 Ln)
±45°
(0°)
• PAL-M/B: 0°, 90°,
180°, 270°
• NTSC:
0°, 180°
(0°)
• Genlock 2
(625 on overlay)
• Genlock
1/Frame
(525 on overlay)
• Auto
23