Setting Enc/Ens6800+ Control Parameters - Harris ENC6800+ Installation And Operation Manual

Chapter 3: Operation

Setting ENC/ENS6800+ Control Parameters

Note
The sequence of options
listed in the Options column
mirrors the sequence
achieved when you move the
Navigation Toggle switch
up.
Note
Bank 1 parameter options
are available for selection on
ENS6800+ modules only.
Table 3-3. Card-Edge Parameter Options— ENC/ENS6800+ Modules
Bank,
Rotary Parameter Name
Switch
0, 0 Bank Select
0, 1 SDI Video Standard
0, 2 For Future Use
0, 3 Black Level
0, 4 Luma Gain
0, 5 Chroma Gain
22
The following table lists all of the available parameters and options for
the ENC/ENS6800+. All parameters clip unless otherwise indicated.
The On/Off combinations of the control LEDs on the card-edge indicate
the active bank number. See
for more information.
Legend
Bold option=Indicates that this is the default setting for the parameter
[RO]=Indicates that parameters are read-only/feedback, and cannot be
used to select controls
All parameters clip unless otherwise noted.
Function
Selects a bank
Selects the video standard input
Adjusts the picture brightness
Adjust the luminous intensity of the
video signal
Adjusts the picture color saturation
"Changing Parameter Settings" on page 20
ENC/ENS6800+ Installation and Operation Manual
Parameter Option
• Bank 0
• Bank 1
• Bank 2
• Bank 3
(These parameters wrap)
• 625
• 525
• Auto
±7.5 IRE
(0 IRE)
±3.0 dB
(0 dB)
±3.0 dB
(0 dB)