Push To Talk (Ptt) Intercom; Ptt Call To A Handset Or Base - AT&T SB67108 User Manual

Handset operation

Push to talk (PTT) intercom

You can directly broadcast messages to the speakerphone of any
extension. The extension you called can respond by pressing the INT
key to begin a two-way communication. Up to five pairs of PTT calls
establish at a time.

PTT call to a handset or base

1. When the handset is idle, press PTT.
2. Press DIR or CID
base.
3. Press and hold PTT until your handset screen shows
PTT to: X:Handset X Release PTT key to stop X:Handset X Release PTT key to stop (X
represents the extension number [1-0]; Handset
X represents the default handset name) or
PTT to: :Base Release PTT key to stop
*
the connection is made, both the caller and the
destination party hear two beeps.
4. Speak into the speakerphone while continuing to peak into the speakerphone while continuing to
hold down the PTT key. Your voice is broadcast to
the desired extension.
Release the PTT key after speaking. There is a
5.
three-second PTT wait state with -MUTE slowly flashing on the
screen. During the PTT wait state, if necessary, you can press and
hold the PTT key to continue speaking into the speakerphone.
6. The destination party can now respond (see Answer a PTT call on
page 41).
NOTE: If the called handset or telephone base is on an intercom or outside call, your
handset sounds a busy signal and displays Busy.
to choose the desired handset or choose the desired handset or
Release PTT key to stop. When
while continuing to
40
PTT
PTT to:
1:Handset 1
Release PTT key
to stop
PTT to:
1:Handset 1
-MUTE