And Charging - AT&T SB67108 User Manual

Getting started
Handset battery installation and charging
Install the battery as shown on the next page. Once you have
installed the battery, the screen indicates the battery status (see table
below). If necessary, place the handset in the charger to charge the
battery. For best performance, keep the handset in the charger when
not in use. The battery is fully charged after 16 hours of continuous
charging. See the table on page 79 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 10 minutes before you can use it. The battery
and Low battery flash, and the handset beeps until you have
icon
charged the battery without interruption for at least one hour. The
following table summarizes the battery charge indicators and actions
to take.
Battery indicators
The screen is blank.
The screen shows
Low battery,
flashes, and the
handset beeps.
The screen shows
Charge completed.
NOTE: In low battery mode, you hear four short beeps per minute. In low battery mode, you hear four short beeps per minute.
Battery status
Battery has no
charge and the
handset cannot be
used.
Battery has enough
charge to be used for
a short time.
Battery is fully
charged.
5
Action
Charge without
interruption for at
least 10 minutes.
The screen shows
Charging.
Charge without
interruption at least
one hour.
To keep the battery
charged, place it in
the charger when not
in use.