Announcement Setup - AT&T SB67108 User Manual

Getting started
Mailbox setup
3. Press PHONE/
phone confirms that the setup of the Alert number is correct.
4. After confirming that the call went to the telephone number you
specified, press
appears.
NOTE: If you try to set If you try to set Alert on/off before you enter the Alert call #, Please set
alert # appears on the screen.

Announcement setup

The announcement is the greeting callers hear when calls are
answered by the handset mailbox.
The handset has the pre-recorded announcement "Hello, please
leave a message after the tone." You can use this announcement, or
replace it with your own recording.
Your announcement can be up to two minutes.
Play the current personal announcement:
1. When the handset is idle, press the M.box softkey.
2. Press DIR or CID
Anncemnt setup. Press
current announcement plays.
3. Press /ENTER or the OK softkey when
MENU
finished.
Record a new personal announcement:
When the handset is idle, press the M.box softkey.
1.
2. Press DIR or CID
setup. Press
announcement.
3. Press the Change softkey, and then press the
Start softkey. The system announces, "Record
after the tone, press Stop when you are done."
or
FLASH
/CLEAR to end the test. The idle screen
OFF
to select
MENU
to scroll to Anncemnt
/ENTER to play current
MENU
SPKR. The ringing of the designated
/ENTER and the
23
1:Handset 1
11:28AM 03/24
M.box CID
0 New Messages
Play all
Deliver
>Anncemnt setup
Back
Play anncemnt
00:01
OK Change
Record anncemnt
Back Start