Assemble The Wing; Assemble The Fuselage - GREAT PLANES FlatOut Flatana Instruction Manual

Assemble the Wing

❏
1. Cut the wing and ailerons from the foam sheet.
❏
2. Insert offset Z-bend clevises (A2) into opposing
sides of two clip hinge control horns. Following the Expert
Tip previously described, use the 3 x 914mm [1/8" x 36"]
wing trailing edge tube as a guide to glue four hinges and
a control horn into each aileron. The control horns should
protrude from the bottom of the ailerons (red and white
side), and the offset Z-bend clevises should be on the
inboard sides of the horns. Remove the tube once the CA
has hardened.
❏
3. Glue a control surface brace (E1) onto the roots of
the ailerons.
❏
4. Slide four hinge retainer rings (C3) onto the wing
trailing edge tube. Position the rings so that they align with
the inner slots in the TE of the wing. Secure each retainer
with a drop of glue on the outside of the gap. Glue the
trailing edge tube to the TE of the wing. Be careful not to get
glue between the rings.
❏
5. Glue the 3 x 915mm [1/8" x 36"] wing leading edge
tube to the LE of the wing.

Assemble the Fuselage

❏
1. Cut the upper and lower vertical fuselage halves
and the right and left horizontal fuselage halves free from
9