Disable Wi-Fi Notifications; Connect To An Ethernet Network - Honeywell Dolphin CT50 User Manual

Chapter 6 — Configure the Computer

Connect to an Ethernet Network

64
Note: Proxy settings apply only to the Wi-Fi network you modify. You
must change proxy settings for each network requiring a proxy server.
1 Open the Settings app and tap Wi-Fi. The list of available Wi-Fi
networks appears.
2 Tap and hold the network name and then tap Modify network. A list
of network settings appears.
3 At the bottom of the list of network settings, select Show advanced
options.
4 If the network has no proxy settings, tap None in the Proxy Settings
list, and then tap Manual in that list.
5 Enter the proxy settings for the network.
6 Tap Save.

Disable Wi-Fi Notifications

By default, when Wi-Fi is enabled, you receive notifications in the Status
bar when the computer discovers a wireless network. You can disable
these notifications.
1 Start the Settings app.
2 Tap and hold Wi-Fi.
3 Tap and then tap Advanced. The Advanced Wi-Fi menu appears.
4 Clear the Network notification check box to disable notifications.
To connect the computer to an Ethernet network, you need an Ethernet
dock.
1 Make sure the dock is connected to your Ethernet network.
2 Place the computer in the dock.
3 Start the Settings app and make sure Ethernet is enabled (Ethernet
is enabled by default).
To enable Ethernet, slide the Ethernet switch on. When the switch
turns blue, Ethernet is enabled.
4 Tap Ethernet. The Ethernet list shows the name of the current
Ethernet connection. By default, the computer assumes a DHCP
connection, and that your network has assigned an IP address
Dolphin CT50 and CT50h Mobile Computer User Guide