Fingerprint Reader Board - HP ZBook Studio G 315-ap000 – 15ap099 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes bracket)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the bottom cover (see
6. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the cable from the system board (1).
2. Lift the tape from atop the fingerprint reader (2).
3. Remove the Phillips PM2.0×3.0 screw that secures the bracket to the computer (3).
4. Slide the bracket downward to disengage it, and then lift the bracket off the fingerprint reader (4).
5. Remove the fingerprint reader from the computer (5).
Reverse this procedure to install the fingerprint reader board.
42 Chapter 6 Removal and replacement procedures for authorized service provider parts
Service door on page
Bottom cover on page
Battery on page 30).
28).
29).
Spare part number
840952-001