Display Assembly - HP ZBook Studio G 315-ap000 – 15ap099 Maintenance And Service Manual

Display assembly

NOTE: The DreamVision display assembly is spared as a whole unit assembly only. The LED display
assembly is spared at the subcomponent level only. For more LED display assembly spare part information,
see the individual removal subsections.
Description
15.6-in, UHD, UWVA, DreamVision display assembly not equipped with a webcam
15.6-in, UHD, UWVA, DreamVision display assembly equipped with a webcam
15.6-in, FHD, UWVA display assembly with a touch screen
To remove the display assembly and access the LED display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service door (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the thermal module (see
8. Remove the display cable (see
9. Remove the solid-state drive (see
10. Remove the WLAN module (see
11. Remove the system board (see
Remove the display assembly:
1. Remove the three Phillips PM2.5×4.0 screws (1) that secure each hinge to the computer.
2. Open the computer as far as possible.
Service door on page
Bottom cover on page
Battery on page 30).
Thermal module on page
Display cable on page
Solid-state drive (M.2) on page
WLAN module on page
System board on page
28).
29).
39).
45).
31).
34).
46).
Component replacement procedures
Spare part number
840945-001
840946-001
840947-001
53