EN
4.2
Assembly
WARNING
Risk of electrical shock and fire if mounted in a damp environ-
ment!
Only mount the controller in an area where the ingress protection is
sufficient (see chapter 13 "Technical data").
4.2.1
Mounting the controller
CAUTION
Risk of injury and damage to the casing when drilling!
Do not use the casing as a drilling template.
Choose a suitable installation site.
Drill the upper fastening hole.
Screw in the screw.
Remove the upper casing.
Hang the case in the recess .
Mark the position of the lower fastening holes ,.
Remove the casing again.
Drill the lower fastening holes.
Rehang the case in the recess .
Screw the case firmly using the lower fastening holes and .
Mount the upper casing.
3
78.138 | 08.1
1
148
164
2
9