Kingspan SC100 Installation And Operating Instructions Manual page 31

[......................] [......................]
Display: .7 Display: .7
[Difference Thermostat] [Difference Thermostat]
T T ? ?
T T ? ?
[...]: 6 K [...]: 6 K
[...]: 3 K [...]: 3 K
Display: .7.3 Display: .7.3
[on] [on]
[off] [off]
Display: .7.4 Display: .7.4
EN
  7.2.8 Difference thermostat function
This function allows a controller output to be controlled depending on
a predefined temperature difference.
When the temperature difference exceeds the defined "on" value, the
output is switched on until the temperature difference falls below the
"off" value. For optimised functionality, unloading of the heat source can
be limited to a particular temperature range, and loading of the heat
target can be limited to a maximum value.
Defining the inputs and the switching values
"Functions" submenu selected, see "Selecting a function"
✓
(chapter 7.2.1).
Differential thermostat activated, see "Activating a function"
✓
(chapter 7.2.1).
Outputs selected, see "Selecting an output" (chapter 7.2.1).
✓
: press button.

 
The display for setting the temperature inputs and the switching

values appears.
SET: press button.

"T" flashes in the display (temperature input for the heat source).

: choose the (heat source's) input.

SET: press button to confirm.

"T" flashes in the display (temperature input for the heat target).

: choose the (heat source's) input.

SET: press button to confirm.

The "on" value flashes after confirmation of the heat target input.

: set the "on" value.

SET: press button to confirm.

The "off" value flashes after confirmation of the "on" value.

: set the "off" value.

SET: press button to confirm.

The settings are saved.

Defining limits for the heat source
: press button.

 
The display for setting the limits (max, min) of the heat source

appears.
SET: press button.

"max" flashes in the display (heat source's maximum value).

: set the maximum value.

SET: press button to confirm.

"min" (heat source's minimum value) flashes after

confirmation of the maximum value.
: set the minimum value.

SET: press button to confirm.

The settings are saved.

78.138 | 08.1
31