Kingspan SC100 Installation And Operating Instructions Manual page 29

V V [....... [.......
................ ................
V V
..........] ..........]
Glykol: 40% Glykol: 40%
Display: .5. Display: .5.
[Without flow sensor] [Without flow sensor]
T T ? [...] ? [...]
T T ? [...] ? [...]
V V
Display: .5.3 Display: .5.3
[hot] [hot]
[cool] [cool]
[............] R1: [............] R1:
max: 0l/Imp max: 0l/Imp
V V
min: 0l/Imp min: 0l/Imp
Display: .5.4 Display: .5.4
[Flow rate] [Flow rate]
EN
 
The display for setting the glycol proportion appears.

SET: press button.

"Glycol proportion" flashes in the display.

: set the value.

SET: press button to confirm.

The settings are saved.

Allocating inputs for temperature sensors
: press button.

 
The display for setting the temperature inputs appears.

SET: press button.

"T" flashes in the display (input for supply temperature).

: choose the desired output.

SET: press button to confirm.

"T" flashes in the display (input for return temperature).

: choose the desired output.

SET: press button to confirm.

Determining the flow rate for the connected solar
circuit pumps
: press button.

 
The display for setting the min/max flow rate appears.

SET: press button.

The "max" value flashes in the display and the pump begins to

run at maximum speed.
The flow rate value must now be read at the pump assembly's flow

rate display.
: enter the flow rate value.

SET: press button to confirm.

The "min" value flashes in the display and the pump begins to

run at minimum speed.
The flow rate value must now be read at the pump assembly's flow

rate display.
: enter the flow rate value.

SET: press button to confirm.

NOTE
• If other solar circuit pumps (e.g. system with  storage tanks) are
connected to the controller, the flow rate for these pumps must be
determined and entered as described here.
• If the minimum pump speed in the "Parameters" menu, or the pump
level at the pump, is changed at a later point in time, the flow rate
must be determined and set once more for more precise calculation
of the heat quantity.
• If the collector is in a stagnant state, pump starts are blocked in
order to prevent damage. A corresponding information window is
displayed.
78.138 | 08.1
9