Kingspan SC100 Installation And Operating Instructions Manual page 30

7.2.7 Thermostat function
This function allows a controller output to be controlled depending on a
pre-defined temperature range. Depending on the temperature setting,
the thermostat function can be activated either when the temperature
falls below (heating) or rises above (cooling) a certain level.
If "on" value is higher than "off" value: If the temperature difference
exceeds the defined "on" value, the output is switched on until the tem-
perature difference falls below the "off" value.
If "on" value is lower than "off" value: If the temperature falls below
the defined "on" value, the output is switched on until the temperature
rises above the "off" value.
Defining the input and temperature values
"Functions" submenu selected, see "Selecting a function"
✓
(see chapter 7.2.1).
Thermostat activated, see "Activating a function" (chapter 7.2.1).
✓
Outputs selected, see "Selecting an output" (chapter 7.2.1).
✓
: press button.

The display for setting the temperature input and the "on" and

"off" values appears.
SET: press button.

"T" flashes in the display (temperature input).

: choose the desired output.

SET: confirm the input.

The "on" value flashes in the display.

: set the "on" value.

SET: press button to confirm.

The "off" value flashes after confirmation of the "on" value.

: set the "off" value.

SET: press button to confirm.

The settings are saved.

NOTE
The "on" and "off" values must not be equal, as otherwise the thermostat
remains inactive.
30
EN
 
[...............] [...............]
T T
Display: .6 Display: .6
[Thermostat] [Thermostat]
 
Display: .6.3 Display: .6.3
[on] [on]
[off] [off]
78.138 | 08.1
on-off on-off
/ /
T T ? ?
[...]: 20°C [...]: 20°C
/ /
[...]: 20°C [...]: 20°C