Pride Jazzy 1113 Owner's Manual page 29

On/Off Key
The on/off key powers the VSI on and off.
WARNING! Unless faced with an
emergency situation, do not use the
on/off key to stop the chair. This will
cause the power chair to stop abruptly.
WARNING! Always turn the power off
when you are stationary to prevent
unexpected movement.
Battery Condition Meter
The battery condition meter is located in front of the
joystick. This is a 10-segment illuminated display that
indicates that the VSI is powered on and also gives the
battery status, the VSI status, and the electrical system status.
n Red, yellow, and green lights lit: Batteries charged;
VSI and electrical system OK.
n Red and yellow lights lit: Charge batteries if
possible; VSI and electrical system OK.
n Red lights only lit or slow flash: Charge batteries
as soon as possible; VSI and electrical system OK.
n Rapid flash of lights: Indicates a fault in the VSI or
the electrical system. Refer to "VSI Error Codes."
n Ripple side to side of lights: The joystick was not
in the neutral position when the controller was turned
on. If you get "ripple side to side of lights," turn off the controller, allow the joystick to return to the neutral
position, then turn on the controller.
NOTE: If you still get "ripple side to side of lights," contact an authorised Pride Provider.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash,
reminding you the batteries need to be charged immediately!
Speed/Profile Keys
There are two keys that control either the speed or the profile. This depends on whether your VSI was
programmed for speed or with a profile. Press the speed/profile increase key to increase the speed or change the
profile. Press the speed/profile decrease key to decrease the speed or change the profile. The speed/profile setting
is displayed on the maximum speed/profile indicator. If your power chair was programmed with a drive profile,
contact an authorised Pride Provider for more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the
slowest setting until you become familiar with your new power chair.
Horn Key
The horn key activates the horn.
Jazzy 1113
V I I . O P E R A T I O N
www.pridemobility.com
Figure 34. VSI Controller Keypad
29