Pride Jazzy 1113 Owner's Manual page 19

To remove the footrest:
Remove the footrest by sliding the mountingbracket up
the vertical bar of the front frame until the tabs on the
mounting bracket can be pulled forward through the
matching slots in the front frame. See figure 13.
To disconnect the controller:
Disconnect the controller connector (and charger inhibit
if equipped) from the electronics tray located at the rear
of the power chair. See figures 7 and 14. You may need
to pull firmly and gently wiggle the connector to remove it
from the socket. For the smaller connector, you must
squeeze the connector latch release levers to disconnect
the connector from the socket.
To remove the seat:
1. Disconnect the controller connector from the electronics tray.
2. Push in the black spring-loaded seat release buttons (one
on the front of each seat frame side tube). See figure 15.
3. While you are pushing both buttons or levers
simultaneously, lift up on the front end of the seat frame.
4. Pull forward on the seat frame to release the locating pins
from their slots in the rear seat posts. You may find it
necessary to wiggle the frame gently from side to side to
free the locating pins from their slots.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so, resulting in personal injury or
damage to the chair.
To remove the battery well frame:
1. Remove the seat from the power base.
2. Disconnect the battery box connectors from the
electronics tray. See figure 16.
3. Remove the battery boxes (with the batteries in them)
from the battery well frame.
4. Disconnect the left motor connector from its matching
socket located on the left frame assembly. Squeeze the
connector latch release levers to disconnect.
5. Disconnect the right motor connector from its matching
socket located on the right frame assembly. Squeeze the
connector latch release levers to disconnect.
Jazzy 1113
I V . D I S A S S E M B L Y
www.pridemobility.com
Figure 13. Footrest Removal
Figure 14. Disconnect the Controller Connector
Figure 15. Seat Removal
SEAT RELEASE BUTTONS
19