Sleep Mode - Pride Jazzy 1113 Owner's Manual

OFF-BOARD CHARGER/PROGRAMMING SOCKET
The off-board charger/programming socket is located on the front of the Remote Plus. If you use an off-
board charger, the charger current should not exceed 12 amps. Contact your authorised Pride Provider for
more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board
charger/programming socket. See your authorised Pride Provider for more information.
NOTE: Changes to the programming can only be made by an authorised Pride Provider.
CONTROLLER COMMUNICATIONS CONNECTOR
The controller communications connector provides the Remote Plus with a connection to the power module.

SLEEP MODE

Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off
the main power if the joystick is not moved in any direction for approximately five minutes. The battery condition
meter lights on the keypad indicate sleep mode by blinking once every five seconds. To restore power and con-
tinue, push the on/off key twice.
THERMAL ROLLBACK
The Remote Plus is equipped with a thermal rollback circuit. This circuit monitors the temperature of the motors,
power module, and remote. In the event that any of them become excessively hot (above 50°C/122° F), motor
voltage is reduced. For every degree above 50°C/122° F, the voltage is reduced by 5 volts. This reduces your
power chair's speed and allows the electrical components to cool down. When the temperature returns to a safe
level, your power chair resumes its normal speed.
REMOTE PLUS ERROR CODES
In addition to indicating the current state of battery charge, the battery condition meter can also indicate possible
problems with your power chair's electrical system. If any of the battery condition meter lights are flashing rapidly, the
controller may be indicating an error. Error codes are displayed as a number of flashing lights. For instance, if the first
light is flashing rapidly, the battery voltage is nearly depleted. The table below identifies the individual error codes,
probable causes, and possible solutions. If you get one of these error codes, contact your authorised Pride Provider.
Flashing Lights Diagnosis
10 High Battery Voltage
9 Solenoid Brake Fault
8 Possible Controller Fault
7 Possible Joystick Fault
6 Inhibit Active
5 Right Motor Wiring Fault
4 Right Motor Disconnected
3 Left Motor Wiring Fault
2 Left Motor Disconnected
1 Low Battery Voltage
40
V I I . O P E R A T I O N
www.pridemobility.com
Solution
Check batteries.
Check motor/brake wiring.
See authorised Pride Provider.
See authorised Pride Provider.
Unplug charger. Check connections.
Check right motor writing.
Check right motor writing.
Check left motor writing.
Check left motor writing.
Check batteries/battery wiring.
Jazzy 1113