Pride Jazzy 1113 Owner's Manual page 46

I X . C A R E
n Check all electrical connections. Make sure they are tight and are not corroded. Batteries must sit flat within
the battery area, with the battery terminals facing inward toward each other. Refer to the frame decal for the
correct wiring layout.
n All wheel bearings are pre-lubricated and sealed. They require no subsequent lubrication.
DAILY CHECKS
n With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the
neutral position when you release it. Check the rubber boot around the base of the joystick for damage.
Visually inspect the boot only. Do not handle or try to repair it. See your authorised service center if there is a
problem.
n Visually inspect the controller harnesses. Make sure that they are not frayed, cut, or have any wires exposed.
See your authorised Pride Provider if there is a problem with any of these harnesses.
Weekly Checks
n Disconnect and inspect the controller from the electronics tray. Look for corrosion. Contact your authorised
Pride Provider if necessary.
n Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any
screws.
n Check for proper tyre inflation. There should be 2.4 bar (35 psi) in each tyre. If a tyre does not hold air, see
an authorised Pride Provider for replacement of the tube.
n Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate
properly. To calibrate the joystick, power off the unit, place the joystick in the neutral position, and power the
unit back on. If a problem still exists with your joystick's performance, contact your authorised Pride Provider.
n Check the brakes. This test should be carried out on a level surface with at least one meter of clearance around
your power chair.
To check the brakes:
1. Turn on the controller and turn down the speed level of your power chair.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You
must be able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this
test three times, pushing the joystick rearwards, then left, and then right.
To calibrate the joystick (Remote Plus only):
1. Position the joystick in the full reverse position and hold it there. Turn on the controller.
2. The battery condition meter lights up from one light to ten lights, and then back to one light. It does this twice,
then blinks rapidly.
3. Turn off the controller.
4. Position the joystick in the full forward position and hold it there; then turn the controller on.
5. The battery condition meter lights up from one light to ten lights, and then back to one light. It does this twice,
then blinks once, and then it blinks continuously.
6. Turn off the controller. Now the joystick and controller are set up to function properly together.
46
A N D
www.pridemobility.com
M A I N T E N A N C E
Jazzy 1113