General Specification - Brymen BM315s User Manual

If the instrument voltage-resistance input terminal has subjected to high voltage transient (caused
by lightning or switching surge to the system) by accident or abnormal conditions of operation, the
series fusible resistors will be blown off (become high impedance) like fuses to protect the user
and the instrument. Most measuring functions through this terminal will then be open circuit. The
series fusible resistors and the spark gaps should then be replaced by qualified technician. Refer
to the LIMITED WARRANTY section for obtaining warranty or repairing service.

GENERAL SPECIFICATION

Display: 3-5/6 digits 6,000 counts
Update Rate: 5 per second nominal
24 Segments Bar graph: 40 per second max
Operating Temperature: 0
Relative Humidity: Maximum relative humidity 80% for temperature up to 31
linearly to 50% relative humidity at 40
Altitude: Operating below 2000m
Storage Temperature: -20
Temperature Coefficient: Nominal 0.15 x (specified accuracy)/
40 C), or otherwise specified
o
Sensing: Average sensing
Pollution Degree: 2
Safety: Double insulation per
IEC/EN61010-2-033 Ed. 1.0, IEC/UL/EN61010-031 Ed. 1.1 and CAN/CSA-C22.2 No. 61010-1-12
C to 40 C
o o
C
o
C ~ 60 C, < 80% R.H. (with battery removed)
o o
IEC/UL/EN61010-1 Ed. 3.0, IEC/EN61010-2-030 Ed. 1.0,
Battery and Fuse replacement
Battery use: 1.5V AAA Size battery x 2
Fuses use:
Fuse (F2) for µAmA current input:
0.4A/1000V ac & dc, IR 30kA, F fuse; Dimension:
6 x 32 mm
Fuse (F1) for A current input:
11A/1000V ac & dc, IR 20kA, F fuse; Dimension:
10 x 38 mm
Battery and Fuse replacement:
Loosen the screw from the access cover of the
case bottom. Lift the access cover. Replace the
batteries or fuse. Re-fasten the screw.
C @ (0
o
C decreasing
o
C ~ 18 C or 28 C ~
o o o
11