Suzuki RM-Z250 Owner's Service Manual page 93

5-6 ENGINE REMOVAL AND INSTALLATION
INSTALLATION
Install the engine in the reverse order of removal. Pay attention
to the following points:
• Fit the swingarm in its position and hold it with the swingarm
pivot shaft.
• Mount the engine on the frame.
• Tighten the engine mounting bolts, nuts and swingarm pivot
shaft nut.
1
2
3
4
5
$ Tightening torque
1, 3 (Bolt, Nut)
2 (Bolt, Nut)
4 (Bolt, Nut)
5 (Bolt, Nut)
6
(Shaft, Washer, Nut)
The engine mounting nut is the self-lock type and can-
not be used repeatedly. If the self-lock effect is lose,
replace it with a new one.
• Install the engine sprocket 7 and snap ring 8.
Replace the snap ring with a new one.
Seat the snap ring in the groove and locate its end as
shown in the illustration.
# 09900-06107: Snap ring pliers
• Reassemble the drive chain clip so the slit end faces opposite
the direction of rotation.
Bolt Length
55 mm (2.17 in)
50 mm (1.97 in)
95 mm (3.74 in)
96 mm (3.78 in)
120 mm (4.72 in)
N·m kgf-m
40 4.0
45 4.5
60 6.0
55 5.5
70 7.0
CAUTION
CAUTION
lb-ft
29.0
32.5
43.5
40.0
50.5
Thrust
Sharp
edge
Direction of travel