Installation - Suzuki RM-Z250 Owner's Service Manual

7-6 CLUTCH

INSTALLATION

Install the clutch plates in the reverse order of removal. Pay
attention to the following points:
• Apply engine oil to the drive plates 1 and driven plates 2.
• Install the push rod and push piece.
• Apply engine oil to the release bearing 3.
NOTE:
The covered side A of the bearing should face outside.
• Fit the pressure plate.
• Install the clutch springs and clutch spring set bolts.
• Hold the clutch housing with the special tool.
Be careful not to damage the clutch housing or clutch
plates.
" 09920-53740: Clutch sleeve hub holder
• Tighten the clutch spring set bolts to the specified torque.
NOTE:
Tighten the clutch spring set bolts diagonally.
$ Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the gasket 4 and clutch cover 5.
Replace the gasket 4 with a new one.
• Tighten the clutch cover bolts diagonally.
$ Clutch cover bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the brake pedal. (!16-18)
INSPECTION AFTER INSTALLATION
• Engine oil level and oil leakage (!2-11)
• Clutch cable play (!2-17)
• Smooth operation of clutch assembly
CAUTION
CAUTION
Outside