Fan; Fan Control; Lamp Runtime; Filter Counter - Panasonic PT-CW230EA Operating Instructions Manual

Setting
PIN code change
The PIN code can be changed to your desired four-
digit number.
1 ) Press ▲▼ to select [PIN code change]
and then Press <SELECT> button.
Current Pin code dialog box appears.
2 ) Press ▲▼ to enter the current code.
Press ► button to fix the number and
move the red frame pointer to the next
box.
The New PIN code input dialog box appears.
3 ) Repeat these steps to set a new PIN
code.

Fan

1 ) Press ▲▼ to select [Fan] and then
Press <SELECT> button.
2 ) Press ▲▼ to select one option .
This function provides the following options in
the cooling fans' operation when the projector is
turned off.
L1
L2

Fan control

1 ) Press ▲▼ to select [Fan control] and
then Press <SELECT> button.
2 ) Press ▲▼ to select one among
options as below.
Choose the running speed of cooling fans from
the following options according to the ground
elevation under which you use the projector.

Off

On1
On2
*1 : Set this function to [Off] when using the projector
in non-high altitude environment.
*2 : Select this mode when using the projector in high
altitudes (about 1,200 meters or more above
the sea level) where the fans have less cooling
effect.
58
- ENGLISH
Normal operation.
Slower and lower-sound than
the normal operation (L1), but
it takes more time to cool the
projector down.
1
Normal speed.*
2
Faster than [Off] mode.*
Faster than [On 1] mode.*
*3 : Select this mode when using the projector in
higher altitudes (than above where the fans have
lesser cooling effect).
Note
Failure to set the running speed of cooling fans
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2].

Lamp runtime

This function is used to display the cumulative lamp
operating time and reset the lamp runtime.
1 ) Press ▲▼ to select [Lamp runtime].
2 ) Press ►or the <SELECT> button to
access the submenu items.

Lamp runtime

Show the total accumulated lamp run time.
Lamp runtime reset
After replacing the lamp unit, be sure to reset the
timer.
1 ) Press ▲▼ to select [Lamp runtime
reset].
2 ) Press the <SELECT> button.
[Lamp runtime Reset?] appears. Select [Yes]
to continue. Another confirmation dialog box
appears, select [Yes] to reset the Lamp runtime.
Attention
When the lamp run time is elapsed the estimated
duration, [Lamp runtime] will be displayed in red
and the Lamp replacement icon ( page 64) will
appear on the screen, indicating that the end of
lamp life is reached. When replacing the lamp unit,
reset the lamp runtime.

Filter counter

This function is used to set a frequency for the filter
replacement.
1 ) Press ▲▼ to select [Filter counter].
3
2 ) Press ►or the <SELECT> button to
access the submenu items.