Power Management; Direct On; Standby Mode; Closed Caption - Panasonic PT-CW230EA Operating Instructions Manual

Setting

Power management

For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period.
1 ) Press ▲▼ to select [Power
management].
2 ) Press ► or the <SELECT> button to
access the submenu.
Mode
1 ) Press ▲▼ and then press the
<SELECT> button to select one mode
among the items as below.
Ready When the lamp has been fully cooled
down, the <ON(G)/STANDBY(R)>
indicator changes to green blinking.
In this condition, the projection lamp
will be turned on if the input signal
is reconnected or any button on the
control panel or remote control is
pressed
Shut When the lamp has been fully cooled
down down, the power will be turned off.

Off

[Power management] function is off.
Timer
1 ) Press ▲▼ to select [Timer] and then
press the <SELECT> button.
2 ) Press ▲▼ to set the Timer(1~30min).

Direct on

1 ) Press ▲▼ to select [Direct on] and
then press the <SELECT> button.
2 ) Press ▲▼ to switch between [On] and
[Off].
When this function is set to [On], the projector
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
projector is turned off in the incorrect sequence,
the [Direct On] function does not work properly.
56
- ENGLISH

Standby mode

This function can set the electric power when the
projector is standing by.
1 ) Press ▲▼ to select [Standby mode]
and then press the <SELECT> button.
2 ) Press ▲▼ to switch between the items
as below.
Restricts some functions in

Eco

standby mode to reduce power
consumption.
Does not restrict functionality
Network
even in standby mode.
Note
When selecting [Network], the cooling fans may be
running depending on the temperature inside the
projector even if the projector is turned off.
Refer to "Operating Instructions - Network Operations
If Standby mode is set to [Eco], you cannot use network
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
the projector is standing by.

Closed caption

[Only for NTSC input]
1 ) Press ▲▼ to select [Closed caption].
2 ) Press ► or the <SELECT> button to
enter the submenu.

Closed caption

1 ) Press ▲▼ to select [Closed caption]
and then press the <SELECT> button.
2 ) Press ▲▼ to select [Off], [CC1], [CC2],
[CC3] or [CC4].
Color
1 ) Press ▲▼ to select [Color] and then
press the <SELECT> button.
2 ) Press▲▼ to select color or white.
Note
The closed caption is mainly used in the north America.
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when [NTSC] signal is
input.
".