Yamaha YZ450FA 2011 Owner's Service Manual page 233

2. Install:
• Handlebar "1"
• Handlebar upper holder "2"
• Bolt (handlebar upper holder) "3"
Bolt (handlebar upper holder):
28 Nm (2.8 m•kg, 20 ft•lb)
• The handlebar upper holder should be in-
stalled with the punched mark "a" forward.
• Install the handlebar so that the marks "b" are
in place on both sides.
• Install the handlebar so that the projection "c"
of the handlebar upper holder is positioned at
the mark on the handlebar as shown.
• First tighten the bolts on the front side of the
handlebar upper holder, and then tighten the
bolts on the rear side.
3. Tighten:
• Nut (handlebar lower holder) "1"
Nut (handlebar lower holder):
34 Nm (3.4 m•kg, 24 ft•lb)
• Cap "2"
Install the cap "2" onto the handlebar lower
holder nut (left).
4. Install:
• Left grip "1"
Apply the adhesive to the handlebar "2".
• Before applying the adhesive, wipe off grease
or oil on the handlebar surface "a" with a lac-
quer thinner.
• Install the left grip to the handlebar so that the
line "b" between the two arrow marks faces
straight upward.
5-39
HANDLEBAR