Menu Items - GCC Technologies RX Series User Manual

3.4

Menu Items

Below describes the functions of menu items
Menu or Key
Roll To measure media width.
Edge To measure media width and pull the media back till the front
paper sensor open.
Single To measure media width and length.
To indicate the power status.
1. To move the tool carriage position on X or Y axis.
2. To select functions or change values of settings.
1. The displayed parameters will be saved automatically.
2. To set a new origin at the present tool carriage position.
In "offline" mode, moving the tool carriage to desired
position by [Arrow Keys], then press [ENTER] key to set a
new origin. While moving with the parameters of XY-axes
displayed, press [MISC] key will enable fine-tune
movement; press [MISC] key again to disable the function.
To temporarily halt the cutting process.
To resume the process by press [Pause/Resume] key again.
1. To switch between online mode and offline mode.
2. To stop the cutting job or abort the change of setting.
Once press this key, the cutting job will be terminated
immediately and cannot be resumed.
To set or modify the distance between the blade tip and the
center axis. Through left or right arrow keys, users can select
the blade used (Red, Green, Yellow, Blue, Black capped
blade or Pen) then adjust the offset values after pressing
Enter if necessary
To set or modify the value of tool force.
When the cutting force exceeds 450g, the maximum cutting
speed would be 30cm/sec and the cutting quality would be
Small Letter Mode and while the cutting force is 300g-449g,
the maximum cutting speed would be 30 cm/sec and the
cutting quality would be Fine Mode.
Speed To set or modify tool speed at horizontal moving.
When the cutting speed exceeds 72 cm/sec, the cutting
quality would be Normal Mode.
Up Speed To set or modify tool speed at vertical moving.
The Control Panel
Function
--- Media sizing ---
--- POWER ---
[ Arrow Keys ]
[ ENTER ]
[ PAUSE/RESUME ]
[ ONLINE/OFFLINE ]
[ OFFSET ]
[ FORCE ]
[ SPEED ]
3-7
RX Series User Manual
Setting Default
Maximum Media
Length 150M
Maximum Media
Length 150M
Maximum Media
Length 10M
0.000~1.000mm 0.275mm
5~600gram; 80 gram
5 gram/per step
3~153cm/sec; 72cm/sec
3cm/sec per step
3~153cm/sec; 72cm/sec
3cm/sec per step