GCC Technologies RX Series User Manual page 53

Cutting Quality To set or modify cutting quality.
While cutting small letter, set as "Small letter".
While cutting in high speed, set as "Draft".
For normal operation, set as "Normal".
Square Cut To perform a cutting test at present blade position.
For more information, please refer to "4.3 Adjusting the
Cutting Force and Offset" to adjust blade force and cutting
speed.
To repeat AAS jobs automatically without having to operate
Repeat AAS
on the computer side.
Job
Please be noted that this feature is mainly applied to the
Single paper mode; please ensure a new piece of material
you wish to apply this feature on is loaded and the origin
repositioned to the first registration mark before starting.
When the first AAS job repeat completes, the user will be
offered the choice of "Repeat AAS Job Again", please
press "Online/Offline" to return to the main menu.
Pattern Setting To provide two patterns for cut test
Note: It is recommended to select "Cross" if you are working
on thick pieces of materials.
Ratio Setting To adjust the size of the pattern
Blade Length To adjust the length of the blade
Adjust Note:
1. Keep your blade length as 0 before you start adjusting.
2. Test the blade holder first and then test the blade length by
pressing ENTER.
3. Keep the blade holder at the same position when you
perform blade holder and blade length tests.
4. When blade holder and blade length tests are finished, the
screen will show you to what degree (the unit of the value
following "CW" or "CCW" is "circle") and in which direction
[CW (clockwise) or CCW (counterclockwise)] you should
turn the adjustment knob.
EG, Turn CW 0.5 is telling you that you should turn the
knob for half a circle clockwisely.
5. The value on the screen will be 0.0 when the blade length
is perfect and no more adjustment needs to be made. You
will be prompted with the message below: Adjustment
completes and you may start cutting at this point.
Redo Jobs in To redo the cut test jobs saved in memory by recutting or
Memory producing cut test copies
To clear up buffer memory.
Set Smoothing To enable smooth-cutting function.
Cut
Over Cut To generate an overcut to facilitate weeding.
The Control Panel
[ CUT TEST ]
[ DATA CLEAR ]
[ TOOL SELECT ]
3-8
RX Series User Manual
Draft, Fair, Normal
Normal, Fine,
Small Letter
"Arrow" and
"Arrow"
"Cross" patterns
100%, 200%, 100%
300%, 400%
0.00mm-5.00mm 0.00mm
Recut (number of Recut
jobs: 1-99)
Copy (number of
jobs: 1-999)
Enable
0.00mm-1.00mm 0.00mm
0.05mm/per step