Mastercook KGE-3416ZB Plus Instruction Manual page 50

EN
Problem
Gas burners fail to ignite
While igniting one of the burners all the
hob burner igniters spark
After setting the knob to simmering flame
position - the flame dies or is too high
Flame is unstable
Parts made of stainless steel (inox) deve-
lop stains that cannot be removed with the
use of standard cleaners
Smoke coming out of the oven
Oven light does not function
– Check to make sure the rubber hose supplying gas from the gas cylin-
der is not squeezed.
– Check to make sure the gas main valve is open.
– Check to make sure the gas cylinder is not empty.
– In case a new cooker has been installed or the gas cylinder has been
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
– Check to make sure the nozzle or burner flame holes are not clogged
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo-
nents.
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
– Avoid draughts in the kitchen,
– Call the fitter to adjust simmering flame position
– Check to make sure that the burner components are clean, dry and
placed correctly.
– Stainless steel surfaces should be cleaned
and only with the use of special stainless steel cleaner.
– Open the windows to air the kitchen,
– When the oven cools down, clean its interior and especially the spit.
– Use the drip tray when grilling foods.
1. Check to make sure the cooker is connected to the electrical mains.
2. The bulb is burnt or not screwed all the way in.
Disconnect the cooker from the electrical mains before fixing the
fault.
– Unscrew glass bowl 1 from light socket 2 and screw bulb 3 all the
way in or replace the bulb with a new one (bulb type: E14 230V 25W,
resistant to temperature of 300
49
Solution
.
each time they get soiled
0 C).