Electronic Programmer; Grilling - Mastercook KGE-3416ZB Plus Instruction Manual

Grilling

Dish
Chicken steak and cutlets
Joint of pork
Sausages
Kebabs
Beef steak
Joint of beef
Veal cutlet
Veal steak
Chicken - a half
Fillet
Krouts
Toast
12.1 General notes
Electronic digital programmer is a modern unit con-
trolling operation of the oven. The programmer in-
dicates current time with the accuracy to 1 minute.
After each completed program, it generates a sound
signal and automatically switches the oven off.
The programmer enables execution of the following
functions:
– setting the current time,
– programming the time of oven operation,
– programming the time of switching the oven off,
– programming the time of operation and time of
switching the oven off in 24-hour cycle,
– setting the timer,
• It is possible to control operation of the oven
not using the programmer - after pressing
button.
• If the automatic control program is complete,
and the dish requires further roasting, then
you may reprogram operation of the oven or
press the manual operation button
control further roasting.
• The programmer may be used as a timer, with
the timer running independently of the pro-
gram.
Programming consists in pressing the button of the
selected function (e.g.
time using „+" setting button. You can adjust the time
using „-" setting button.
Time [min] on one side
10 - 15 (on the inside)
and
) and setting the desired
8 - 10
10 - 12
8 - 10
7 - 8
6 - 7
10 - 12
6 - 8
6 - 7
6 - 7
2 - 3
3 - 5
Pressing „+" or „-" setting buttons for a short time cau-
ses change of time by one minute, and depressing
them for a longer time - activating the quick scroll
mode.
Programming:
– press and release the button of the selected
function,
– during the time up to 5 seconds after releasing of
the function key, set the required time using „+"
and possibly „-" setting buttons; if during these
5s programming is not started - the called func-
tion will disappear,
– after approx. 5s from the end of programming,
the programmer will display the current time and
starts to execute the program.
The following graphic symbols may appear on the
programmer display:
„AUTO" -
Automatic operation symbol
Continuous lighting means that the program is
being executed. Pulsing informs about the end
of the program (the programmer is waiting for
re-programming or switching over to the manual
operation cycle).
-
Locking symbol
The oven may be protected from change of set-
tings or accidental activation, especially by chil-
dren.
-
Oven operation signal
Continuous lighting signals operation of the oven
(providing that it is switched on).
-
Timer signal
Continuous lighting means that the timer is set.
44
Table 6
Time [min] on the other side
6 - 10
6 - 8
6 - 8
5 - 6
5 - 6
10 - 12
6 - 8
5 - 6
10 - 12 (on the outside)
4 - 5
1 - 2
2 - 3
EN