Table of Contents
Advertisement
Available languages
Available languages
EN
A - Automatic operation;
B - Hours;
C - Oven operation symbol;
D - Minutes;
E - Timer symbol;
F - Lock symbol;
1 - timer button;
2 - operating time button;
3 - operation end button;
4 - manual operation button;
5 - time „decreasing" setting button;
6 - time „increasing" setting button
•
When the cooker has been connected to the
power supply mains, pulsating messages
„0.00" and „AUTO" appear on the program-
mer display.
•
The first action which should be taken upon
connection of the cooker to power supply is
set-ting the current time.
•
The current time should be set also after de-
cay of voltage in the mains lasting longer
than 5s.
•
Accuracy of the programmer readings de-
pends on parameters of the supply mains,
therefore it should be adjusted periodically
by comparing it with another timer.
12.2 Setting the current time
–
simultaneously depress
–
using „+" (and possibly „-") setting button set the
required time e.g. 11.38,
–
when the time has been set, release all buttons.
During the time of approx. 5s from releasing of the
buttons, the time will be stored. The time set i.e.
11.38 will appear on the display. When the current
time is set, the oven will run in the manual mode.
12.3 Switching off the sound signal
•
After completion of each program, the oven will be
switched off automatically, and the sound signal
will be activated.
•
After certain time, the sound signal will be switched
off automatically.
and
buttons,
45
•
The user may switch off the sound signal earlier by
depressing any button of the programmer.
12.4 Timer
The timer is designed for sound signalling when the
time set elapses. You can use it when performing
short time cooking operations (e.g. boiling eggs).
The timer does not switch the oven off.
•
when the time is being measured out by the ti-
mer, you can program operation of the oven,
•
the timer can be set during execution of any pro-
gram.
Setting the timer:
–
press
button,
–
using: „+" and possibly „-" setting buttons set the
desired time (e.g. 3 minutes).
After approx. 5 s the current time will appear on the
display and
indicator will be illuminated. When
the time set (i.e. 3 minutes) elapses, the sound si-
gnal will be activated. The signal can be disabled by
pressing any button.
Deleting the timer setting:
–
press
button,
–
press „-" setting button and hold it till the messa-
ge „0.00" appears on the display,
NOTE !
In order to check how much time is left till the
end of the timer operation, press
pressing of this button does not stop measuring
of time.
12.5 Programming the oven operating time
When the time of operation has been programmed
and the oven function selected, the oven will be
switched on immediately.
Programming the time of operation:
–
press
button,
–
using „+" and possibly „-" setting buttons set the
required time of operation e.g. 35 minutes
When the time set elapses, the following occurs:
–
the oven is switched off automatically,
–
sound signal is activated,
–
the symbol „
AUTO" pulsates on the programmer
display and the symbol
If further operation of the oven is needed (e.g. in or-
der to finish baking of a cake), you may reprogram
the time, or press the manual operation button
and control further operation of the oven.
When the operation is over, move the functional knob
button. De-
is off.
Advertisement
Table of Contents
