Table of Contents
Advertisement
NETWORK SECURITY
HTTP
The camera can send alarm messages to a specific Hypertext Transfer Protocol (HTTP) site
when motion is detected or when the sensor input is activated. You can assign alarm messages
to up to two HTTP sites.
IP Filtering
IP Filtering allows you limit access to your IP cameras by IP address. You can "Allow" or "Deny" a
specific IP address by adding it to the appropriate list. IP addresses on the "Allowed IP List" will
be able to access the IP camera. IP addresses on the "Deny IP List" will NOT be able to access
the IP camera.
IEEE 802.1XSEAP-TLS
This is a well supported security protocol commonly used by wireless vendors. This security
method requires a valid CA certification and key. When properly configured, all communication
between the client (usually a recorder) and the camera is encrypted.
33506AA
47
Advertisement
Table of Contents
