Adjusting The 90º Table Stop And Re-Aligning The Angle Pointer - General International 90-290 Setup & Operation Manual

1. Push the table locking lever B to the left to unlock the
table.
2. Loosen the table lock knob C and tilt the table until
it is at the desired angle. (Refer to the angle indica-
tor A.)
3. Re-tighten lock knob C and push locking lever B to
the right to lock the table in position.
ADJUSTING THE 90º TABLE STOP AND RE-ALIGNING THE ANGLE POINTER
To ensure that your 90º cuts are square and that angled cuts are accurate with the angle indicator scale, the table
default position must be set to 90º to the blade and the angle indicator pointer must be set to read 0 when the table
is in the default (90º ) position.
To set the table-stop bolt:
1. Loosen table locking lever A and table lock knob B.
2. Place a combination square C flat on the table with the heel of the square flat against the saw blade D.
3. Level the table until it is exactly 90° to the blade, then tighten locking lever A and lock knob B.
4.
Using a 19 mm open end wrench, loosen the jam
nut E on the 90º table-stop bolt, then adjust the
height of the bolt F until it touches the underside of
the table.
5. Loosen table locking lever A and table lock knob
B and make sure the table is resting on the table-
stop bolt.
6.
Check the square and make sure the table is still at
90° to the blade. If not, re-adjust the table-stop bolt.
7. Re-tighten jam nut E.
You will now be able to accurately return the table to the 90º position automatically without further adjustments and
scale reading for any angle other than 0 will also be accurate.
B
A
F
E
D
8.
With the table set to 90º and the stop bolt at the
correct height, make sure the table tilt angle indi-
cator pointer is set to read 0º.
9.
If the pointer needs to be adjusted, loosen the
screw G on the pointer of the front trunnion and
adjust the pointer H to the 0 point on the scale.
Then re-tighten the screw to secure the pointer in
place.
A
C
B
C
H
G
13