Attaching The Machine To The Cabinet; Installing The Table And The 90° Stop - General International 90-120 Setup & Operation Manual

BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE "OFF" POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
ASSEMBLING THE CABINET (CONTINUED)
9. Attach the door using 2 screws with washers and a
Phillips screwdriver.
INSTALLING THE MACHINE ON THE CABINET
THE BANDSAW IS HEAVY. DO NOT OVER-EXERT. THE HELP OF ASSISTANTS WILL BE NEEDED FOR THE FOLLOWING STEP .
DO NOT GRIP THE BANDSAW BY THE LOWER WHEEL COVER DOOR WHEN LIFTING. KEEP HANDS AWAY FROM BLADE
AT ALL TIMES.
1.
Place the machine on the cabinet with the help of
two assistants.
INSTALLING THE TABLE AND THE 90° STOP
1.
Insert the stop with the jam nut into the mounting
hole in the frame, then tighten the nut under the
frame by hand.
A
10. Place the assembled cabinet upright on a flat sur-
face.
B
2. Align the 4 mounting holes in the machine with their
corresponding holes in the cabinet, then insert a
countersunk screw B into each hole. Secure the ma-
chine to the base by tightening 4 nuts with washers
under the machine inside the cabinet with a 10 mm
wrench.
2.
Install the table on its base by guiding the blade
through the table slot as shown.
11