UNPACKING
Carefully unpack and remove the unit and its components from its shipping container and check for missing or
damaged items as per the list of contents below.
NOTE: Please report any damaged or missing items to your GENERAL® INTERNATIONAL distributor immediately.
LIST OF CONTENTS
A- BANDSAW (NOT SHOWN) ........................................... 1
B- MITER GAUGE STORAGE BRACKET ............................. 1
C- HANDWHEEL HANDLE* ................................................ 1
D- WOOD SCREW* ........................................................... 3
E- HEX NUT* ...................................................................... 3
F-
RIP FENCE STORAGE BRACKET .................................... 1
G- EYEBOLT* (
Model 90-380 only)
H- WOODEN AUXILIARY FENCE* ..................................... 1
I-
FOOT BRAKE (
Model 90-290 only)
J- MITER GAUGE .............................................................. 1
K- 12-14 MM OPEN END WRENCH* ................................ 1
L-
3 MM ALLEN KEY* ....................................................... 1
M- 4 MM ALLEN KEY* ....................................................... 1
N- 6 MM ALLEN KEY* ....................................................... 1
O- 8 MM ALLEN KEY* (
Model 90-290 only) .......................... 1
P- PUSH HANDLE ............................................................... 1
Q- 10 MM OPEN END WRENCH* .................................... 1
R- FRONT FENCE LOCK KNOB * ...................................... 2
S- SQUARE NUT* ............................................................... 2
Note: Deluxe Excalibur Universal Bandsaw Rip Fence System
is packaged separately. Refer to the manual supplied in the
box with the Excalibur Rip Fence for complete list of contents.
*
Packaged in the box with the Excalibur Rip Fence System.
ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person for help with lifting
• Phillips screwdriver
• Flat head screwdriver
• Feeler gauge set
• Combination square
CLEAN UP
The protective coating on the saw table prevents rust from
forming during shipping and storage. Remove it by rub-
bing with a rag dipped in kerosene, mineral sprits or paint
thinner. (Dispose of potentially flammable solvent-soaked
rags according to manufacturer's safety recommenda-
tions.)
A putty knife, held flat to avoid scratching the surface, may
also be used to scrape off the coating followed by clean-
up with solvent. Avoid rubbing the saw's painted surfaces,
as many solvent-based products will remove paint.
To prevent rust, apply a light coating of paste wax or
use regular applications of any after-market surface pro-
tectant or rust inhibitor.
8
QTY
..................................... 2
................................ 1
B
*
G
F
J
I
P
*
*
*
*
L
O
N
M
Tip: With a screw driver, push a solvent-saturated rag into
the T-slots to remove the grease so the miter gauge will
slide freely.
*
D
*
C
*
E
*
H
*
K
*
Q
*
R
*
S