Table of Contents
Advertisement
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
ADJUSTING THE CUT ANGLE
1.
To unlock the swivel base push lever A to the left as
shown.
ADJUSTING THE SWIVEL BASE LOCK LEVER
1.
If the lever does not lock the base securely, loosen
the screw C with a 6 mm Allen key while holding the
lever in place on its shaft.
ADJUSTING AND USING THE VISE
D
1.
Position the workpiece in the vise and secure it in
place using the vise handwheel D.
16
A
C
2.
Refer to the graduated scale B at the base of the
saw head to set the blade to the required angle.
2.
Turn the lever to the right, and then retighten the
screw A. Make sure the lever locks the swivel base.
If not, repeat steps 1 & 2.
2.
Lock the workpiece in place by turning the quick
locking lever to the left as shown.
B
Advertisement
Table of Contents
