Search With Service Id - Kathrein UFS 913si Operating Instructions Manual

After calling up the menu you will see the
following on-screen display:

The buttons allow you to select
different sets of parameters for the search.
Satellite

Use the buttons to select the satellite that is transmitting the channels to be searched.

By pressing the button at this point, you can view a list of the installed satellites. Use the
to select the satellite you want and confi rm with the
aligned to this/these satellite(s).
Transponder Frequency

Use the buttons (transponder frequency already saved) or the number pad (transponder
frequency not yet saved) to select the transponder frequency on which the channel being sought
is transmitted. By pressing the
for the selected satellite. Use the

button. At the bottom right of the screen display, the receiver shows the current signal strength
and signal quality of the selected transponder.
The "DVB Type", "FEC", "Polarisation" and "Symbol Rate" selection items need be entered only
if the transponder has yet to be saved.
DVB Type

Use the buttons to select whether you want to search for standard channels (DVB-S (SD)) or
for HDTV channels (DVB-S2 (HDTV)).
FEC

Use the buttons to select the applicable error rate (Viterbi rate). When searching for
DVB S(SD) transponders you need not state the error rate. Instead a fi xed display of "Automatic"
appears. When searching for DVB S2(HD) transponders you must state the correct error rate.
Either QPSK 1/2, 2/3, 3/4, 3/5, 4/5, 5/6, 8/9, 9/10 or 8PSK 2/3, 3/4, 3/5, 5/6, 8/9 or 9/10.
Main Menu - Search Channels

Search with service ID


button at this point, you can view a list of the transponders stored

button to select the desired transponder and confi rm with the

button. Make sure your reception system is

buttons
93