Automatic Channel Search - Kathrein UFS 913si Operating Instructions Manual

After calling up the menu you will see the
following on-screen display:

The buttons allow you to select
different sets of parameters for the search.
Satellite

Now use the
the setting "All". If "All" is selected, all the individual satellites you have set up will be searched for
new channels. Make sure your reception system is aligned to this/these satellite(s).
Channel Search Mode

Use the buttons to select the type of channels you want to search for. You have three options:
- "free & scrambled"
- "only free"
- "only scrambled"
To view encrypted channels you need an appropriate CA (Conditional Access) module and
a valid smart card together with a valid subscription to the relevant Pay TV provider.
Network Search

Use the buttons (On/Off) to select whether a network search should be performed. If you set
the network search to "Off", only the factory stored transponders of the satellite(s) you previously
selected will be searched for new as yet unlisted channels. If you set the network search to "On", the
transponder network enables additional transponders that have not yet been stored to be located. They
are then stored and scanned for new channels in the same way as the existing transponders. Once you
have defi ned all the settings, use the
and confi rm the start of the search using the
Main Menu - Search Channels

Automatic Channel Search

buttons to choose between the individual satellites you have set up, or select
All channels are searched for
Only free-to-air channels are searched for
Only encrypted channels are searched for


buttons to switch to the "Start Search" selection fi eld
button.
89