Programming The Turbo Steamer - Expobar ROSETTA CAPSULE GROUP User Manual

PROGRAMMING

Programming the turbo steamer

To program the temperature at which the turbo steamer will stop automatically:
Press the Continuous Dispensing button
dispensing button light will flash and all of the button panel lights will be turned on (see fig. 02).
Insert the steam wand (with built-in temperature gauge) in the jug containing the milk and press the
Continuous Dispensing button
will start dispensing steam and will heat the milk in the jug (see fig. 03).
When the milk reaches the desired temperature, press
The new heating temperature will be saved.
Note:
i
Use a thermometer to measure milk temperature when programming the turbo steamer.
To adjust the amount of air injected into the steam, and therefore the creaminess of the
steamed milk, contact service personnel.
and hold it down for 8 seconds. The continuous
on the left-hand button panel. The automatic steam wand
Fig. 02
Rosetta Capsule Group
again to stop dispensing.
Fig. 03
27