Table of Contents
Advertisement
To eliminate this phenomenon, reduce the
amount of light by stopping down the lens and
newly set a higher gain value. Then, the output
signal from the CCD element at the saturating
area will be appropriately saturated into a white
level for the output.
(Note) The above described unnatural image
represents the following states:
● Black and white look inverted at the saturating area.
● The outline of the saturating area is blurred.
● The saturating area slightly shifts upward or downward.
● The brightness of the saturating area does not reach 1023.
(5-5) Program page setting
The FC series cameras are internally equipped with nonvolatile memories
then various operation mode settings and level settings can be stored in
them.
The setting items are stored in the virtual pages (hereinafter referred to as
"program pages") inside the camera.
This camera has 6 program pages of "A", "B", "C", "D", "E" and "F" (right
figure).
Refer to section 6 for more information about Program page setting and
Readout of Program page at start-up.
[Electronic shutter operation mode]
• Shutter system = Continuous/asynchronous
• T ype of shutter speed = High speed/ low speed
• Electronic shutter table = Correspondence relation
b/w shutter switch position and shutter speed
[Other operation modes]
• Scanning system = Normal /Partial
[Level setting]
• Gain setting value = (Saved as the internal value)
• Offset = ( Saved as the internal value)
And others
- 13 -
K09821;13/37
Program page F
Program pages from B to E
Program page A
Fig.5-5 Program pages
Advertisement
Table of Contents
