GigE FC11000GE Instruction Manual page 10

Operation confirmation buzzer
(4-6)
This equipment is designed to sound the confirmation buzzer of "pip" when a stroke is applied to the UP/DOWN switch on
the rear panel, or at the time of other manipulation including the start-up after power application.
The factory default setting is ON. This setting can be changed to cancel the buzzer.
[Procedure for switching buzzer between ON/OFF]
(1) Start up in the Setting group 3.( Set the mode switch to the position "C", keeping the power to the camera off. Then
turn on the power of the camera while turning and keeping the UP/DOWN switch lever to the either of upper or lower
position).
(2) Return the UP/DOWN switch lever to the neutral position when the response sound of "pip-pip" is heard
(3) Change the position of the mode switch to "2" after confirming that LED indicator flashes in orange.
(4) The buzzer sound gets ON by stroking UP/DOWN switch upward and gets OFF by stroking that downward.
(5)
Turn off the power following the completion of setting . Since the setting is automatically saved, the camera starts up
with the last setting when the power is reapplied from next time.
(4-7) Camera ID saving function
The ID code and other information set by the user for each camera can be stored in the camera and be read out when
needed. The saved identification data for each camera including installation location in the case of using more than one
camera (e.g., "CAMERA-RIGHT" and "CAMERA-LEFT") allows the user to easily control and identify the camera (s).
The setting is executed through the serial communication. The settable maximum number of characters are 15, and
alphabets (both upper and lower cases), numbers and some special symbols such as"+" and "-" excluding the control
codes can be used.
(→ Refer to the section of "Serial Communication Control" for the details.)
(4-7) Automatic Correction Function
The CCD in this equipment has 2ch output ports (right and left), and the image signal can be read out in high speed from
both ports.(Dual mode) At that time, the right and left halves of image data are synthesized to make a full area picture
image bringing together at a center boundary of the screen. Then the right and left output may differ in level, as the both
output characteristics are not exactly the same. This equipment has the automatic correction function to reduce and
obscure the level difference at the boundary. The factory default of this function is OFF. It can also correct the level
difference manually deactivating the automatic correction function. Depending status of camera usage, difference in level
or border line may appear on the center boundary. However, it does not arise from camera failure.
(4-8) Auto Iris Signal (IRIS) output circuit
This signal is effective as Auto Iris control signal only in no shutter mode or continuous shutter mode.
Signal output level
Output impedance
Asynchronous signal
0 to 0.7 V (DC)
75
Ω
No signal
＋３ ． ３ Ｖ
Fr o m
in t e rn a l c i rc u i t
Ａ Ｍ Ｐ
- 10 -
K09821;10/37
＋ ３ ．３ Ｖ
７ ５Ω
３
Ｉ Ｒ Ｉ Ｓ s i gn a l