Configuring Security Settings Of Multiple Ssids - ZyXEL Communications WAP3205 v2 User Manual

For example, you may set up three wireless networks (A, B and C) in your office. A is for workers,
B is for guests and C is specific to a VoIP device in the meeting room.

8.5.1 Configuring Security Settings of Multiple SSIDs

The WAP3205 v2 is in access point mode by default. If you want to use multiple SSIDs when the
WAP3205 v2 is in universal repeater mode, see
v2 to universal repeater mode.
This example shows you how to configure the SSIDs with the following parameters on your
WAP3205 v2 (in access point mode).
SSID
SSID_Worker
SSID_Guest
SSID_VoIP
Connect your computer to the LAN port of the WAP3205 v2 using an Ethernet cable.
1
Open a web browser such as Internet Explorer and type "http://zyxelsetup" as the web address in
2
your web browser.
Enter "1234" (default) as the password and click Login.
3
Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.
4
Go to Configuration > Network > Wireless LAN > General. Configure the screen as follows. In
5
this example, you select Enable Intra-BSS Traffic for SSID_Worker and SSID_Guest to allow
wireless clients in the same wireless network to communicate with each other. Click Apply.
Chapter 8 Tutorials
A
SSID_Worker
B
SSID_Guest
SECURITY TYPE
WPA2-PSK
WPA Compatible
Static WEP 128bit
WPA-PSK
WAP3205 v2 User's Guide
SSID_VoIP
Chapter 5 on page 31
KEY
DoNotStealMyWirelessNetwork
keyexample123
VoIPOnly12345678
62
C
for how to set the WAP3205
MAC FILTERING
Disable
Disable
Allow
00:A0:C5:01:23:45