ZyXEL Communications WAP3205 v2 User Manual page 35

Note: Wireless clients cannot use WPS to set up a wireless network with the WAP3205 v2
in universal repeater mode.
Figure 20 Universal Repeater: WLAN > WPS
The following table describes the labels in this screen.
Table 15 Universal Repeater: WLAN > WPS
LABEL DESCRIPTION
WPS Setup
Enable WPS Select this to turn on the WPS feature.
Apply Click Apply to save your changes back to the WAP3205 v2.
Station Site Survey
# Use the radio button to select the wireless device to which you want to connect using WPS.
SSID This displays the SSID of the wireless device.
BSSID This displays the MAC address of the wireless device.
Signal Strength This displays the strength of the wireless signal. The signal strength mainly depends on the
antenna output power and the distance between your WAP3205 v2 and this device.
Channel This displays the channel number used by this wireless device.
Encryption This displays the data encryption method used by this wireless device.
Authentication This displays the authentication method used by this wireless device.
WPS State This displays YES (configured) when WPS has been set up on the wireless device.
This displays NO (unconfigured) if WPS has not been set up on the wireless device.
PIN This displays the PIN number of the WAP3205 v2.
Renew PIN Click this button to generate a new PIN and display it in the PIN field.
PIN Start Click this button to perform wireless security information synchronization using the PIN
configuration method.
PBC Start Click this button to perform wireless security information synchronization using the Push
Button Configuration (PBC) method.
Rescan Click this button to search for available for WPS-enabled devices within transmission range
and update this table.
Chapter 5 Universal Repeater Mode
WAP3205 v2 User's Guide
35