ZyXEL Communications WAP3205 v2 User Manual page 58

Channel
Security
Follow the steps below to configure the wireless settings on your WAP3205 v2.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Set your WAP3205 v2 to work as an access point. See
1
Open the Wireless LAN > General screen in the AP's Web Configurator.
2
Enter SSID_Example3 as the SSID and select a channel or select Auto Channel Selection to
3
have the WAP3205 v2 scans for and select an available channel automatically. Click Apply.
Click the Security tab.
4
Select the SSID (SSID_Example3) for which you want to configure the security. Set security mode
5
to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.
Open the Status screen. Verify your wireless and wireless security settings under Device
6
Information and check if the WLAN connection is up under Interface Status.
Chapter 8 Tutorials
Auto
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
WAP3205 v2 User's Guide
58
Section 6.2 on page
Section 2.1.1.1 on page
41).
14.