4.3.1 Setting your WAP6806 to AP Mode
By default, AP mode in the WAP6806 is not configured with a static IP address. To setup your
WAP6806 in AP mode for the first time, the directly-connected router must have the DHCP server
function enabled.
Connect one end of an Ethernet cable to the Ethernet port on the WAP6806 and the other end to
1
your router.
Connect your computer to your network, make sure both the WAP6806 and computer are under the
2
same subnet.
Open a web browser window and type "http://zyxelsetup" or "http://192.168.1.2" in the web
3
address.
The login screen displays.
Enter "1234" (default) as the password and click Login.
4
Type a new password and retype it to confirm, then click Change. Otherwise, click Skip.
5
The WAP6806 Web Configurator displays, which allows you to configure the AP mode. See
7.3 on page 33
4.3.2 Configuring your WLAN, LAN and Maintenance Settings
• See
Chapter 12 on page 62
wireless network and LAN settings.
• See
Chapter 14 on page 76
4.4 AP Mode Status Screen
Click
to open the Status screen.
Chapter 4 Access Point Mode
for details.
and
Chapter 11 on page 60
for information on configuring your Maintenance settings.
WAP6806 User's Guide
for information on configuring your
24
Section