Restart Screen - ZyXEL Communications WAP3205 v2 User Manual

Table 50 Maintenance > Backup/Restore
LABEL
Upload
Reset

12.8 Restart Screen

System restart allows you to reboot the WAP3205 v2 without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 80 Maintenance > Restart
Click Restart to have the WAP3205 v2 reboot. This does not affect the WAP3205 v2's
configuration.
Chapter 12 Maintenance
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the WAP3205 v2 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the WAP3205 v2 again. The WAP3205 v2 automatically restarts in this
time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the WAP3205 v2 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
WAP3205 v2. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
WAP3205 v2 User's Guide
105