Step 3 - Connecting An Output; Single Wire Pcm; Sdif-2 Pcm Interface - DCS Scarlatti Upsampler User Manual

dCS Scarlatti Upsampler User Manual
STEP 3 – Connecting an Output
Choose which output interface you want to use and connect it up as described below. You can
connect as many outputs as you wish.
If the output format is not compatible with a particular interface, that interface will not be
!
active (for example, the
The Upsampler will not output sample rates that are lower than the input sample rate.

Single wire PCM

Connect one or more of the PCM outputs (AES1, AES2, RCA1, RCA2) to matching inputs on your
DAC. Use the
OUTPUT
96kS/s. Use the DAC's
From source equipment
AES
DIGITAL INPUTS
ANALOGUE OUTPUTS
LEFT RIGHT
L R
Balanced - or - Unbalanced
Analogue Outputs
To pre- or power amplifier inputs
Go to STEP 4.

SDIF-2 PCM interface

Connect the SDIF
CH1
Upsampler are not locked to a master clock, also connect the Upsampler's
DAC's Word Clock Input. Use the
32, 44.1, 48, 88.2 or 96kS/s. Use the DAC's
Go to STEP 4.
Filename: Scarlatti Upsampler Manual v1_1x.docx
output cannot carry DSD).
AES1
button on the front panel to set the output sample rate to 32, 44.1, 48, 88.2 or
button to select that input.
INPUT
SDIF
RCA1 CH2
TOSLINK CH1
BNC
IN OUT
RCA2
W/CLOCK
LEFT
DIGITAL INPUTS
AES 1 AES 2
RIGHT
L R
Figure 1 – Connecting the single-wire outputs
& outputs to the matching inputs on your DAC. If the DAC and the
CH2
button on the front panel to set the output sample rate to
OUTPUT
INPUT
From USB source
RCA1
AES 1 AES 2
RCA2
1394
DIGITAL OUTPUTS
Connect one or
more outputs
RCA 1
DSD/SDIF
CH 1 CH 2
TOSLINK
SPDIF
BNC
OUT
IN
RCA 2
WCLK
button to select the SDIF-2 input.
Page 9
Software Issue 1.1x
August 2011
Scarlatti Upsampler
~
50/60 Hz, 30W
USB
FUSE
SUC
T 500mA L
Scarlatti DAC
~
1394 50/60 Hz, 50W
FUSE
SUC
T 500mA L
Output to the
W/Clock
English version