Configuring Local User Database; Table 26 Radius - ZyXEL Communications G-3000H User Manual

The following table describes the labels in this screen.

Table 26 RADIUS

LABEL
Index
Profile Name
Primary
Backup
Active
RADIUS Server IP
Address
RADIUS Server Port
Share Secret
Active
Accounting Server IP
Address
Accounting Server Port Enter the port number of the external accounting server. The default port
Share Secret
Apply
Reset

6.15 Configuring Local User Database

To change your ZyAIR's local user database, click the WIRELESS link under ADVANCED
and then the Local User Database tab. The screen appears as shown.
Chapter 6 Wireless Security Configuration
DESCRIPTION
Select the RADIUS profile you want to configure from the drop-down list box.
Type a name for the RADIUS profile associated with the Index number above.
Configure the fields below to have user authenticate and accounting through
external servers.
If the ZyAIR cannot authenticate a wireless station(s) using the Primary
RADIUS server or communicate with the Primary accounting server, you can
have the ZyAIR use a Backup RADIUS server. Make sure the Active check
boxes are selected if you want to use backup servers.
The ZyAIR will attempt to communicate three times before using the Backup
servers. Requests can be issued from the client interface to use the backup
server. The length of time for each authentication is decided by the wireless
client or based on the configuration of the ReAuthentication Timer field in the
in the Security screen.
Select the check box to enable user authentication through an external
authentication server. Clear the check box to enable user authentication using
the local user profile on the ZyAIR.
Enter the IP address of the external authentication server in dotted decimal
notation.
Enter the port number of the external authentication server. The default port
number is 1812. You need not change this value unless your network
administrator instructs you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyAIR. The key must be
the same on the external authentication server and your ZyAIR. The key is not
sent over the network.
Select the check box to enable user accounting through an external
authentication server.
Enter the IP address of the external accounting server in dotted decimal
notation.
number is 1813. You need not change this value unless your network
administrator instructs you to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyAIR. The key must be
the same on the external authentication server and your ZyAIR. The key is not
sent over the network.
Click Apply to save your changes back to the ZyAIR.
Click Reset to begin configuring this screen afresh.
G-3000H User's Guide
83